The ALGAE-X Fuel Polishing Systems keep diesel and middle distillate fuels in “pristine condition”. There are numerous configurations. The TC Series of Tank Cleaning Systems are for high volume (over 1,300 gallon) tank configurations and come in two configurations rated at 16 and 25 gph.
The FPS system is designed for up to 1,300 gallon tank configurations, and is available in two varieties. The FPS-500 is a 12V DC (or 24V DC) system for use on vessels with tanks up to 1,000 gallons at a circulation rate of 150 gph. The FPS-750 system is a 110V AC (or 230V AC) for use on vessels with tanks up to 1,300 gallons at a circulation rate of 210 gph.
All of these systems are ideal for use on tanks of vessels, vehicles, generators and heavy equipment.
Stage 1: The ALGAE-X Fuel Conditioner reverses the process of fuel deterioration, buildup of tank sludge and stabilizes the fuel.
Stage 2: The centrifugal water separation system removes water.
Stage 3: The fine filter removes solid contaminants. Water Block filters are available for removal of water, even emulsified water, from your fuel.
These wall mounted fuel polishing systems providing Optimal Fuel Quality for Peak Engine Performance. Since fuel is inherently unstable, solids begin to form and the accumulating tank sludge will eventually clog your filters and damage your injectors. It will cause engines to smoke, lose power and ultimately break down.
The Fuel Polishing process conditions and stabilizes the fuel, eliminates microbial contamination, removes water, tank sludge and contaminants from the tanks. The principal components of the systems are an LG-X Magnetic Fuel Conditioner (MFC)that is sized for the flow requirements of the application, a continuous duty gear pump, a timer and a fuel filter/water separator and, on the TC units, a coalescer with a vacuum gauge. The Magnetic Fuel Conditioner decreases the size and mass of fuel droplets which leads to better filtration and water separation, clear and bright fuel, optimal combustion and clean tanks.
These systems are compact, easy to install, operate and maintain. The ALGAE-X MFC unit is self-cleaning, has no moving parts, no electrical hookup, and requires zero maintenance. The filter/water separator unit removes water and particulate from the fuel. It can be easily drained by opening the valve on the bottom. The filter element can be back-flushed several times before replacing.
INSTALLATION
1. Mounting:
The unit should be sized to your particular requirements and should be wall mounted on a hard, level surface. These units are designed for well-ventilated indoor use and should be located as close to the tank as possible. Allow about 3” of space on top of the unit to change the filter element comfortably and sufficient space on the bottom to drain the system. This space is also necessary to ensure sufficient ventilation of cooling air for the motor.
2. Electrical:
Make sure that the motor has the same rated voltage as your electrical system. FPS systems are available in 12V DC, 24V DC (FPS-500), 110V AC and 230V AC (FPS-750 or TC units). The system connects to the positive lead from your battery with the red wire of the motor and to the negative lead with the black wire. After the initial wiring of the motor check system operation to insure that it is running in the correct direction. If the motor is running in the wrong direction, reverse the two electrical leads.
